Add layout files for various wafers: aepwafer, bcdwafer, fwafer, xwafer, zwafer, and zwafer_rev

assets/layouts/bcdwafer.yaml

@@ -0,0 +1,46 @@
+# This will be the name of the output files
+name: bcdwafer
+wafers: ["B", "C", "D"]
+
+# round or square wafer
+shape: round
+
+# diameter/edge size of the wafer
+size: 300
+
+# large or small markers and labels
+marker_size: large
+font_size: large
+
+# origin settings.  x_origin can be left, right, or center.  y_origin can
+# be top, bottom, or center.  Using right or top implies that the X/Y values
+# for that axis are negative, or else we'll be drawing outside the image.
+x_origin: center
+y_origin: center
+
+# sensor X and Y values, in mm relative to the origin
+X: [0, 72.50, 125.57, 145.00, 125.57, 72.50, 0, -72.50, -125.57, -145.00,
+    -125.57, -72.50, 0, 47.50, 82.27, 95.00, 82.27, 47.50, 0, -47.50, -82.27,
+    -95.00, -82.27, -47.50, 38.97, 22.50, -38.97, -22.50, 0]
+Y: [145.00, 125.57, 72.50, 0, -72.50, -125.57, -145.00, -125.57, -72.50, 0,
+    72.50, 125.57, 95.00, 82.27, 47.50, 0, -47.50, -82.27, -95.00, -82.27,
+    -47.50, 0, 47.50, 82.27, 22.50, -38.97, -22.50, 38.97, 0]
+
+# set this to either 0 or 1 for the initial sensor number (usually 1)
+start_sn: 1
+
+# Normally, positive X is to the right, and positive Y is up.
+# These settings can be used to reverse one or both of these.
+reverse_x: false
+reverse_y: false
+
+# these are sensors whose labels need to be repositioned.  Sensor numbers
+# start at start_sn.  Directions are up, down, left, and right, and values
+# are multiples of the marker size.
+label_exceptions: {
+    2: { left: [1, 0] },
+    3: { left: [1, 0] },
+    4: { left: [1, 0] },
+    5: { left: [1, 0] },
+    6: { left: [1, 0] },
+}